System control operation, Connection, 1, automatic play operation – Kenwood KR-V9020 User Manual
Page 12: 2, synchro recording, 3, remote control, System control operation 2
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
System control operation
■ii
ii
ill
ill
l);j ^
i S'
Connection
Using the system control cords provided with KENWOOD system component models, make
connections as shown below.
Turntable
Except for some areas,
* For a cassette deck to
be subject to system
control operation, it
must be connected to
the TAPE 1 jacks.
—
—
pi
□ f
■ Connection of the audio cords and sys
tem control cord
Make sure that the audio cords are connected correctly
right and left as in the figure.
If the system control cord and audio cords are not
connected properly, the automatic system governing re
mote control and system functions will not operate.
(For connections of the audio cords, refer to the "System
connections" diagram.)
By connecting this unit to KENWOOD cassette deck, CD
player, and turntable models equipped with system con
trol jacks, the following integrated operation features
become available.
Operation
1, Automatic play operation
When starting play with the turntable, cassette deck, or
CD player connected to the receiver, press the desired
input selector keys on the receiver. The turntable,
cassette deck, or CD player will automatically enter
play mode.
In the same way, pressing the Play key of the turntable,
cassette deck, or CD player will automatically switch
the input selector on the receiver to the component on
which the Play key is pressed,
2, Synchro recording
To record the sound from the CD player or turntable
onto a tape with the cassette deck, press the CD or
PHONO of the input selector keys and load a CD or
record. Set the cassette deck to rec pause mode, then
press the PLAY (START) key of the CD player or
turntable. The cassette deck will start recording auto
matically. synchronized with the CD player or turntable
starting play.
3, Remote control
The remote control unit provided with this unit, to
which a KENWOOD system turntable, cassette deck, or
CD player is connected, is equipped with related
control keys. The related components can be con
trolled using these keys.
Mote: -------------------------------------------------------------- -------------- ----------
During recording with a cassette deck, the input selector on the
receiver is fixed at the source from which the recording is made,
bv the .sv.stem control circuit. At thi.s time, nre.ssina anv of the