Listening to broadcasts, To listen to radio broadcasts, Tuning methods auto tuning – Kenwood KR-V9020 User Manual
Page 20: Ilii
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Listening to broadcasts
TUNING(/CHARACTER) keys
Band selector keys
To listen to radio broadcasts
:i'l
||l
1, Press the POWER key to ON,
2. Press the TUNER input selector key.
3. Press the AM or FM band selector key,
4, Tune in the desired broadcasting station according to
the instructions in the "Tuning methods'" section be
low.
• During tuning, sound is not heard because the muting
circuit is activated. The sound will be heard suddenly
as soon as a station is received,so be careful in
setting the sound volume level,
5. When the desired station is received, adjust the volume
with the VOLUME CONTROL knob.
, I
H
ilii
■ Tuning methods
Auto tuning
When the TUNING key is pressed, broadcast frequencies
are scanned automatically in the upward or downward
direction until a station is located and tuned in. The
stereo/monaural FM reception mode is set automatically
according to the station,
1. Press the AUTO key so that the AUTO indicator lights,
2. Press the UP {[A) or DOWN ([Vl) segment of the
TUNING key.
• Pressing the UP ([7\]) segment scans broadcast fre
quencies by varying the displayed frequencies in the
upward direction, and pressing the DOWN ([V])
segment scans by varying the frequencies in the
downward direction,
• When a broadcasting station is received, the fre
quency display freezes and indicates the frequency of
the received station.
3. If the received station is not the desired station, press
the same segment of the TUNING key again.
• Repeat this until the desired station is received.
Manual tuning
Stations with weak signal strength cannot be received by
auto tuning. In such cases, tune in the desired station by
manual tuning. The station will be received in monaural
mode (monaural mode is resistant to noise),
1. Press the AUTO key so that the AUTO indicator is off,
2. Press the UP (|7\|) or DOWN ([Vl) segment of the
TUNING key,
• Every time the TUNING key is pressed, the displayed
frequency varies by one step in the direction indi
cated by the pressed segment.
• Holding the TUNING key depressed varies the dis
played frequency continuously.
3. When the frequency of the desired station is tuned in,
release the TUNING key,
• Noise may be heard if the tuned frequency is not
precisely the same as the frequency of the station. In
such cases, press the UP ([A]) or DOWN ([V} seg
ment of the TUNING key to adjust the tuning pre
cisely.