Toshiba TEC B-30 Series User Manual
Page 31
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Advertising
5. Load the ribbon.
a. Guide the edge of the ribbon around the ribbon shaft.
b. Place the ribbon rolls onto the two shafts.
c. Insert the ribbon between the ribbon end sensor.
EM1-33004
Ribbon Shaft
Ribbon Shaft
Figure 4-3.
Figure 4-4.
6. Lock the ribbon rolls.
a. Match the notch on the supply and rewind reels with the protrusion on the
shafts as shown.
Protrusion
Figure 4-5.
4-2
Advertising