Black mark or feed gap sensor, Label issue sensor (for on-demand type), Black mark or feed gap sensor -12 – Toshiba TEC B-30 Series User Manual
Page 41
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Advertising
The sensors detect black marks or feed gaps. The adjustment shafts move the
sensors in and out.
4.1. Black Mark or Feed Gap Sensor
Adjust the position of the sensor according to the length, from the left end of the
supply to the black mark or from the center of the feed gap.
EM 1-33004
4. ADJUSTING THE SENSORS
NOTICE:
Which sensor is used depends on the conditions of supply,
4.2. Label Issue Sensor (for On-demand type)
Adjust the position of the label issue sensor to the blank portion of the issued label
(the portion where no characters are printed).
Figure 4-25.
4-12
Advertising