Toshiba TEC EM1-31059 - Manual (Page 64)

7. PROGRAMMING PROCEDURES
EM 1-31059
Menu No. 15
Menu No. 15
• Setting Department Number
When initial set #10-6 is set to “1”, the six-digit PLU # is divided into two; the upper two digits are
assigned to department #, and the lower four digits to PLU #.
The present default department # has priority. The department # is automatically added before the
top of the four-digit PLU # and treated as a six-digit PLU #. Any department # other than the default
can be set on the rightmost column of six keys on the Speed Keyboard.
The default department # refers to the department # of a product which the scale essentially handles,
and any other department # to the department # of a product which the scale does not essentially
handle but may handle.
In case of “PROG.”, “X (Read)", and “Z (Reset)” modes, PLU # is treated as a six-digit number. So
the upper two digits are not treated as department #. Consequently the four-digit PLU # is available
only in each mode of “REG.”, “M.DOWN”, and “REWRAP”. For example, in case of setting PLU
data by programming menu #1, a six-digit number must be set for PLU #. At the same time the
upper two digits of PLU # must match one of the department #.
Select programming
menu #15.
DEPT. KEY
P 15
PROG.
Enter the default
department #.
(1~99)
Enter the department
key #. (1 —6)
Enter the department
#. (1-99)
ENTER DEPT. KEY #
P15
AUTO
CODE 2 -I
ENTER
DEFAULT DEPT. #
ENTER
P15 dF 12
ENTER DEPT. KEY #
P15 dF 12
DEPT. KEY #
P15 dl 12
DEPT. KEY #
P15 dl 20
ENTER
ENTER DEPT. KEY #
P15 dl 20
1 r DEPT. KEY
PROG. (Select another
programming menu.) P 15
7-46