Menu no. 16, Logo – Toshiba TEC EM1-31059 User Manual
Page 65
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
7. PROGRAMMING PROCEDURES
EM 1-31059
Menu No. 16
Menu No. 16
• Transferring Logo Data
When initial set #10-7 is set to “1”, the logo containing a picture, a mark, a POP message, etc., can
be printed on the ingredient label measuring about 18 mm (118 vertical dots) by about 42 mm (320
horizontal dots) and having 12 lines or more.
Logo data is created on the PC and stored into RAM through the CMT interface. 64K bytes of RAM
memory is required to store logo data, then the RAM will store up to 13 kinds of logos. The RAM
area to store logo data is 64K bytes following the RAM area to store PLU data. When logo data is
stored in RAM, and the RAM capacity to store PLU data (initial set #1-1) is changed, the logo data
will be all cleared.
LOGO
P
16
ENTER THE NUMBER
P16
WRIT LOGO TO CMT
P16
1
VERFY LOGO = CMT
P16
2
READ LOGO FM CMT
P16
3
ex.)
IN PROCESS
P16
P 10
Number of logo
LOGO
16
NOTES: 1. The error mode can be released by depressing the CLEAR key, and operated again
through the above steps.
2.
Use the metal cassette tape which is commercially available and has a capacity of 45
or 60 minutes recording.
3.
For operations of the CMT loader, refer to the instruction manual provided with the
CMT loader.
7-47