Cisco 700 - Manual (Page 107)

Provisioning the ISDN BRI Line C-11
Configuration Requirements for Lucent 5ESS Custom Switch
This section describes the router configuration requirements when using Cisco 700 series
routers with an Lucent 5ESS Custom switch.
Point-to-Point Configuration
Table C-8 lists the router configuration requirements when using an Lucent 5ESS Custom
switch in a point-to-point configuration.
Table C-7 NI1 Configuration
Parameter Configuration Software Command
Router software U.S. version – 1
1 This parameter is not set with a software command.
Switch type NI1 set switch
SPIDs At least one required 2
2 The Cisco 765, Cisco 766, Cisco 775, and Cisco 776 require two SPIDs so that the basic telephone service
ports (POTS) operate correctly.
set spid
Directory number At least one required set directory number
Table C-8 Lucent 5ESS Custom Point-to-Point Configuration
Parameter Configuration Software Command
Router software U.S. version –
1
1 This parameter is not set with a software command.
Switch type 5ESS set switch
SPIDs None required –
2
2 This parameter is not set when SPIDs are not used because it might cause unpredictable results.
Directory number Optional set directory number