Cisco 700 - Manual (Page 73)

Troubleshooting Cisco 700 Series Routers 5-11
96 0060 Mandatory
information
element is missing The receiving equipment received a message that
did not include one of the mandatory information
elements. This is usually due to a D-channel error.
If this error occurs systematically, report it to your
ISDN service provider.
97 0061 Message type
non-existent or not
implemented The receiving equipment received an
unrecognized message, either because the
message type was invalid or because the message
type was valid but not supported. Cause 97 is due
to either a problem with the remote configuration
or a problem with the local D channel.
98 0062 Message
incompatible with
call state or
message type
non-existent The remote equipment received an invalid
message, and no standard cause applies. Cause 98
is due to a D-channel error. If this error occurs
systematically, report it to your ISDN service
provider.
99 0063 Information
element
nonexistent or not
implemented The remote equipment received a message that
includes information elements, which were not
recognized. This is usually due to a D-channel
error. If this error occurs systematically, report it
to your ISDN service provider.
100 0064 Invalid information
element contents The remote equipment received a message that
includes invalid information in the information
element. This is usually due to a D-channel error.
101 0065 Message not
compatible with
call state The remote equipment received an unexpected
message that does not correspond to the current
state of the connection. This is usually due to a
D-channel error.
102 0066 Recovery on timer
expiry An error-handling (recovery) procedure was
initiated by a timer expiration. This is usually a
temporary problem.
111 006F Protocol error,
unspecified An unspecified D-channel error when no other
standard cause applies.
Table 5-2 ISDN BRI Cause Values and Cause Messages (continued)
Cause
Value
1
Hex
Value
2 Cause Message Definition