Cisco 700 - Manual (Page 69)

Troubleshooting Cisco 700 Series Routers 5-7
6 0006 Channel
unacceptable The service quality of the specified channel is
insufficient to accept the connection.
7 0007 Call awarded and
delivered The user is assigned an incoming call that is
connected to a channel with an established call.
16 0010 Normal call
clearing Normal call clearing has occurred.
17 0011 User busy The called system acknowledges the connection
request, but is unable to accept the call because all
B channels are in use.
18 0012 No user responding The connection cannot be completed because the
destination does not respond to the call.
19 0013 No answer from
user (user alerted) The destination responds to the connection
request, but fails to complete the connection
within the prescribed time. The problem is at the
remote end of the connection.
21 0015 Call rejected The destination is capable of accepting the call,
but rejected the call for an unknown reason.
22 0016 Number changed The ISDN number used to set up the call is not
assigned to any system. (If an alternate address is
assigned to the called equipment, it might be
returned in the diagnostic field of this message.)
26 001A Non-selected user
clearing The destination is capable of accepting the call,
but rejected the call because it was not assigned to
the user.
27 001B Destination out of
order The destination cannot be reached because the
interface is not functioning correctly, and a
signaling message cannot be delivered. This
might be a temporary condition, but could last for
an extended period of time. For example, the
remote equipment might be turned off.
Table 5-2 ISDN BRI Cause Values and Cause Messages (continued)
Cause
Value
1
Hex
Value
2 Cause Message Definition