Cisco 700 - Manual (Page 106)

Cisco 700 Series Router Installation Guide
Router Configuration Requirements
C-10
Router Configuration Requirements
This section is a list of configuration requirements for Cisco 700 series routers when using
specific switch types. After your ISDN line is ordered and installed, if your router does not
automatically detect the switch type, you can use the configuration information in this
section to configure your Cisco 700 series router.
Configuration Requirements for NI1
Table C-7 lists the router configuration requirements when using Cisco 700 series routers
with an Lucent 5ESS NI1 switch in a multipoint configuration.
Note The NI1 switch does not support a point-to-point configuration.
Issue 2 (NI1) –
TEI DYNAMIC
CACH No
CS Yes
Call transfer Yes
3-way call conferencing Yes
EKTS Yes
Set Option 2 call appearances
1 If connecting at U interface.
2 A blank cell indicates that the configuration option is not applicable to the line
provision.
Table C-6 Northern Telecom DMS-100 Provisioning Summary
(ACOU Not Supported) (continued)
Line Provision Configuration