Roland RSS-10 - Manual (Page 18)

Selecting the MCR-8 Mode
To control the RSS-10 with the Multi Controller MCR-8, select the MCR-8 Mode by taking the
following procedure. To cancel the MCR-8 Mode, simply repeat the same procedure.
The mode you select here will be retained even when the RSS-10 is switched off.
(PROCEDURE)
The MRC-8 Mode has been preprogrammed from the manufacturer.
1 , 2
1. Press [OPTION] and make sure that the indicator is lit. Then press [FUNCTION] once. "MCR-8"
in the Function Mode Indicators will light, showing that the RSS-10 is set to the MCR-8 Mode, and
is controllable with the MCR-8.
2. Press [OPTION], and the indicator will go out.
The indicator will go out after a few seconds, even without pressing [OPTION].
Lock Function (ON/OFF)
The Lock function is provided to protect the current settings on the panel from the accidental loss
that may occur through pressing buttons by mistake. When the Lock function is turned on, the
current settings will not change even by pressing the other buttons.
To turn on the Lock function, press [LOCK] for more than two seconds. The indicator will be lit and
the current setting will be locked.
To turn off the Lock function, press [LOCK] again for more than two seconds. The indicator will
go out.
Bypass Function (ON/OFF)
C=3
LOCK
trm
OPTION
If you wish to output an exact copy of the signal input to the RSS System, turn on the Bypass function.
To turn on the Bypass function, simply press [BYPASS]. When the Bypass function is turned on,
the indicator will be lit. To turn off the Bypass function, press the button again.
18