Roland RSS-10 - Manual (Page 20)

Baud Rate Setting (19,38)
To connect an external device to the Serial Port on the RSS-10, you must set the Baud Rate (speed
for data transfer) so it is compatible with the external device being connected. The Baud rate was
set to 38.4 kbps on the RSS-10 when itwasshipped.Tochangeitto 19.2 kbps, perform the following
procedure. The baud rate you set here will be retained even when the RSS-10 is switched off.
(PROCEDURE)
1 , 2
jj
niK CTK lM
oaio
moofuif
<=> IP \s& C=3
ivnuM
c=>
DKHO LO CK oPtm
1,3
1. Press [OPTION] and make sure that the indicator is lit. Then press [DEVICE ID] once. The current
baud rate is shown in the Display Window.
2. While the baud rate is being displayed, press [DEVICE ID] to change to a different baud rate.
3. Press [OPTION], and the indicator will go out.
The indicator will go out after waiting for a few seconds, even without pressing [OPTION].
Setting the Speaker Angle (12, 24, 30,36,48,60, 72,84)
when the Output Mode is set to SPEAKER, you can set the speaker angle of the RSS-10 depending
on the angle of the speakers location. The value represents the extent of the angle from the listening
position to the center position and the speaker. The default is 30 degrees. If you wish to set a different
angle, do as follows. The angle you set here will be retained even while the RSS-10 is switched off.
(PROCEDURE)
LOCK OrriMt::’' imuM
1 , 2
Ju
1.3
1. Press [OPTION] and make sure that the indicator is lit. Then press [OUTPUT] once. The speaker
angle currently selected is shown in the Display Window.
2. Press [OUTPUT] to change to the desired speaker angle.
3. Press [OPTION], and the indicator will go out.
The indicator will go out after a few seconds, even without pressing [OPTION].
20