How to operate the rss-10 using the mcr-8, Initial settings for the rss-10, Function mode setting – Roland RSS-10 User Manual
Page 21: Initial settings for the mcr-8, Setting the computer switch, Setting the mode switch, Setting up the mcr-8, Initial settings
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
HOW TO OPERATE THE RSS-10 USING THE MCR-8
By connecting the Multi Controller MCR-8 (optional) to the RSS-10, the RSS-10 can be controlled using the MCR-8. To use
the MCR-8, read the following explanation carefully.
*
The RSS-10 comes with a Template that shows how the controller of the MCR-8 correspond to the parameters of the
RSS-10. You can put the Template on the MCR-8.
Setting up the MCR-8
To set up the MCR-8 to the RSS-10, do as follows:
Initial Settings
To control the RSS-10 from the MCR-8, set each device as follows:
Initial Settings for the RSS-10
Function Mode Setting
Set the Function Mode on the RSS-10 to "MCR-8 Mode."
* You do not need to change the Serial Port Switch and Baud Rate.
Initial Settings for the MCR-8
Setting the Computer Switch
Set the Computer Switch on the MCR-8 to "MIDI."
Setting the Mode Switch
Set the Mode Switch on the MCR-8 to "MODE 4."
21