Interlogix TruVision 960H Premium Resolution Series PTZ Cameras Configuration Manual - Manual (Page 12)

Chapter 2: Programming
10 TruVision Analog PTZ Camera Configuration Manual
Camera address settings
To change the camera address settings:
1. Go to Main Menu > System Settings > System Infor Settings.
2. Set the soft address of the PTZ camera.
If Soft Address Active is set to On, the soft address is the valid address for connecting
the PTZ camera. Select a value between 1 and 255.
If Soft Address Active is set as Off, the hard address set by the DIP switch is the valid
address of the PTZ camera.
Note: Before setting the soft address of the PTZ camera, you need to confirm that it is
within the control range of the control device (e.g. the DVR).
After you enable/disable the soft address, the PTZ camera reboots automatically to
activate the settings.
3. Set the broadcast address of the PTZ camera.
When Broadcast Address is set to On, the control device with address 0 can control all
PTZ cameras connected to it.
Soft baud rate settings
To change the soft baud settings:
1. Go to Main Menu > System Settings > System Infor Settings.
2. Set the soft baud rate.
If Soft Baud Active is set to On, there are 4 selectable baud rate: 2400, 4800, 9600
and 19200.
If Soft Baud Active is set to Off, the baud rate depends on the DIP switch settings.
Note: After you enable/disable the soft baud rate, the PTZ camera reboots automatically
to activate the settings.
Pelco checksum
If the PTZ camera uses PELCO-P or PELCO-D protocol, set the Pelco Checksum to On to
get better response when there is a delay in signal transmission and PTZ reaction.
System time
To change the system time:
1. Go to Main Menu > System Settings > System Infor Settings.
2. Use the direction buttons to move the cursor to Sys Time and click IRIS+ to enter.
3. Click the left/right buttons to move the cursor on the item (year/month/day or
hour/minute/second) that you want to change.