Interlogix TruVision 960H Premium Resolution Series PTZ Cameras Configuration Manual - Manual (Page 14)

Chapter 2: Programming
12 TruVision Analog PTZ Camera Configuration Manual
To change the display setting:
1. Go to Main Menu > System Settings > System Infor Settings > Display
Settings . The Display Settings menu appears.
2. Use the direction buttons to move the cursor to the target item and click IRIS+ to
enter.
3. Click the up/down buttons to select the desired value, such as On or Off.
4. Click IRIS+ button to confirm and exit.
Note:
If you enabled both the ZOOM and PT options, the preset label is displayed on screen
while calling the preset.
The PTZ camera displays the viewing direction while you are manually controlling it to
rotate. The zero point must be defined as “North” when initially configuring the camera.
See Table 2 below.
Table 2: Description of the display direction information
Display N NE E SE S SW W NW
Description North Northeast East Southeast South Southwest West Northwest
Fan control
Set Fan Control as Temp (controlled by the temperature), On or Off.
EIS (Electronic image stabilization) function
Set the EIS Function as On or Off.
Preset direct focus
Set the preset direct focus function On/Off from the Preset DFocus submenu.
Protocol and RS-485 settings
The PTZ camera allows you to configure the protocol via the OSD menu.
To set the protocol and RS-485 setting:
1. Go to Main Menu > System Settings > System Infor Settings .
2. Set Protocol Active to On to enable the user-defined protocol.
3. Under Protocol , select the desired protocol from the list: UTC RS-485, PELCO-D,
or PELCO-P.
4. Set the RS-485 configuration diagnosis.
Set 485Check to On or Auto for automatic RS-485 configuration diagnosis. If the
configuration is incorrect, an alert will be received by users; if you set the value as
AUTO, it will finish the diagnosis if no error in the configuration is detected