Interlogix TruVision 960H Premium Resolution Series PTZ Cameras Configuration Manual - Manual (Page 34)

Chapter 2: Programming
32 TruVision Analog PTZ Camera Configuration Manual
scan, tilting scan, random scan, frame scan, panoramic scan, day mode, night mode, or
none. You can also set the alarm output for the alarm.
To configure an alarm priority.
1. Go to MAIN MENU > SYSTEM SETTINGS > ALARM > ALARM SETTINGS .
2. Move the cursor to PRIORITY and click IRIS+ to enter edit mode.
3. Set the alarm priority as HIGH , MIDDLE or LOW .
If multiple alarms with different priorities are triggered at the same time, the PTZ camera
only responds to the alarm with the highest priority. If multiple alarms with the same
priority are triggered at the same time, then the PTZ camera responds to each alarm
according to the defined alarm sequence.
Alarm parameters
Set the alarm related parameters as described below for linkage action interval, alarm
duration and camera activity resumption.
To configure alarm parameters:
1. Go to MAIN MENU > SYSTEM SETTINGS > ALARM .
To configure the interval of the alarm sequence:
When more than one alarm of the same priority occurs at the same time, the PTZ camera
responds to one alarm first and then responds to the next one after the user-defined
interval. Set the interval in the
ALARM SEQUENCE submenu. The value can range
between 1 and 200 seconds.
To configure the alarm rest delay:
If there a linkage action has already been triggered by an alarm input, the PTZ camera only
responds to the input from the same channel again after the user-defined reset delay time.
This is the rest time that the PTZ camera considers an alarm to be active when it is
physically cleared. Set the interval in the
ALARM DELAY submenu. The value can range
between 0 and 250 seconds
To resume camera activity:
Set ALARM RESUME to ON to enable the PTZ camera to resume its previous activity after
the triggered actions has finished.
Notes: If the PTZ camera is moving when a linkage action is triggered, it stops at the
current position and resumes from this position once the linkage action is finished. The PTZ
camera can be configured to resume the PTZ positions, focus and iris value.
Auxiliary alarm output
An auxiliary output is a configurable alarm output interface on the PTZ camera back box
which can connect and trigger another alarm device to operate. See