Interlogix TruVision 960H Premium Resolution Series PTZ Cameras Configuration Manual - Manual (Page 35)

Chapter 2: Programming
TruVision Analog PTZ Camera Configuration Manual 33
Figure 14: Aux menu
To configure an alarm priority:
1. Go to MAIN MENU > SYSTEM SETTINGS > AUX .
2. Move the cursor to AUX1 and click IRIS+ to enter edit mode.
Note: Two auxiliary outputs can be configured.
3. Set the alarm output type as OPEN (normally open) and CLOSE (normally closed).
4. Move the cursor to DWELL TIME . Set the duration of the auxiliary output signal. Select
a value between 0 and 60 seconds.
5. Link the auxiliary output to the configured alarm.
Enter MAIN MENU > CAMERA SETTINGS > ALARM > ALARM SETTING . Select the
alarm number to which to link the auxiliary output.
Move the cursor to AUX and click IRIS+ to configure the auxiliary output to the alarm.
Select NONE to disable auxiliary alarm outputs, 1 to activate AUX 1, or 2 to activate
AUX 2.
Password
You can change as well as enable/disable the password to set the camera authentication to
prevent unauthorized changes to the camera settings. After you set and enable the
password, you need to enter the password each time you call preset 95 to enter the menu.
See Figure 15 on page 34.