Interlogix TruVision IP Camera Configuration Manual - Manual (Page 28)

2BChapter 3: Camera configuration
24 TruVision IP Camera Configuration Manual
Select the level of sensitivity to motion as well as the target size so that only
objects that could be of interest can trigger a motion recording. For example, the
motion recording is triggered by the movement of a person but not that of a cat.
You can define the area on screen where the motion is detected, the level of
sensitivity to motion, the schedule when the camera is sensitive to detecting
motion as well as which methods are used to alert you to a motion detection
alarm.
You can also enable dynamic analysis for motion. When there is motion, the area
will be highlighted as green.
Figure 9: Motion detection menu
Defining a motion detection alarm requires the following tasks:
1. Area Settings: Define the on-screen area that can trigger a motion detection
alarm and the detection sensitivity level.
2. Arming Schedule: Define the schedule during which the system detects
motion.
3. Recording schedule: Define the schedule during which motion detection can
be recorded. See “Recording schedule” on page 30 for further information.
4. Linkage: Specify the method of response to the alarm.