Snapshot parameters – Interlogix TruVision IP Camera Configuration Manual User Manual
Page 32
2BChapter 3: Camera configuration
28
TruVision IP Camera Configuration Manual
3. Click
Edit
to set the arming schedule for the alarm input. See “To set up
motion detection” for more information.
4. Check the checkbox to select the linkage method.
5. Click
Save
to save changes.
To define alarm output:
1. In the
Events
folder, click the
Alarm Output
tab to open its window.
2. Select one alarm output channel from the
Alarm Output
drop-down list. You
can also set a name for the alarm output.
3. The delay time can be set to 5sec, 10sec, 30sec, 1min, 2min, 5min or 10min.
The delay time refers to the time duration that the alarm output remains in
effect after alarm occurs.
4. Click
Edit
to set the arming schedule for the alarm input. See “To set up
motion detection” for more information.
5. Click
Save
to save changes.
Snapshot parameters
You can configure scheduled snapshots and event-triggered snapshots. The
captured snapshots can be stored in the SD card (if supported) or the NAS
.
You
can also upload the snapshots to an FTP server.
Figure 11: Snapshot menu