Rs-485 settings – Interlogix TruVision IP Camera Configuration Manual User Manual
Page 37
: Camera configuration
TruVision IP Camera Configuration Manual
33
To set up the RS-232 settings:
1. In the
System
folder, click the
RS232
tab to open its window.
2. Select the RS-232 port parameters.
Note:
If you want to connect the camera using the RS-232 port, the RS-232
parameters must be the same as those configured here.
3. Click
Save
to save changes.
RS-485 settings
The RS-485 serial port is used to control the PTZ of the camera or connect to
light and wiper devices. Configuration of these parameters should be done
before you connect to any devices.
To set up RS-485 settings:
1. In the System folder, click the
RS485
tab to open its window.
2. Select the RS-485 port parameters.
Note: The Baud Rate, PTZ Protocol, and PTZ Address parameters should be
exactly the same as the PTZ camera parameters.
3. Click
Save
to save changes.