Interlogix TruVision IP Open Standards Outdoor Cameras User Manual - Manual (Page 26)

2BChapter 3: Network and streaming configuring
22 TruVision Outdoor IP Camera User Manual
Configuration folders Description
Network parameters Defines the network parameters required to access the
camera over the internet. See “Network parameters” on page
22.
Serial settings N/A.
Deployment time Defines the schedules during which events are registered.
See “Events scheduling” on page 28.
User management Defines who can use the camera, their passwords and access
privileges. See “User management” on page 37on page 37.
HDD management Defines how to format the SDHC card used in the camera.
See “Formatting the SDHC card” on page 39.
Remote upgrade Defines how to upgrade the camera’s firmware. See
“Upgrading the firmware” on page 40.
Default Restores default settings. See “Restoring default settings” on
page 40.
Reboot device Reboots the camera. See “Rebooting the camera” on page
41.
Information about the camera
Use the “Basic information” menu to define the camera name and RS-485 bus
ID. The default device name is “IP Camera” and device ID is 88. The camera can
have up to 12 alphanumeric characters in its name.
Several parameters are also prepopulated and cannot be changed manually
such as the camera, encoder, panel and hardware versions.
Network parameters
Accessing the camera through a network requires that you define certain network
settings. Use the “Network Parameters” folder to define the network settings. See
Figure 8 on page 23 for further information.
Note: When a network parameter is modified, the camera will prompt you to save
and reboot.