Interlogix TruVision IP Open Standards Outdoor Cameras User Manual - Manual (Page 34)

3BChapter 4: Configuring the camera
30 TruVision Outdoor IP Camera User Manual
Parameter Description
Max bit rate Specifies the maximum allowed bit rate. A high image resolution
requires that a high bit rate must also be selected.
Options include: 32 bps, 48, 64, 80, 96, 128, 160, 192, 224, 256, 320,
384, 448, 512, 640, 768, 896, 1024, 1536, 1792, 2048, Custom (enter a
value manually). Default value is 2048.
Frame rate Specifies the frame rate for the selected resolution.
The frame rate is the number of video frames that are shown or sent per
second. Default value is 25 (PAL)/ 30 (NTSC).
I-frame interval A video compression method. It is strongly recommended not to change
the default value displayed: 25.
Multicast address Specifies a D-class IP address between 224.0.0.0 to 239.255.255.255.
You do not need to specify this option if you are not using the multicast
function. Some routers prohibit the use of multicast function in case of a
network storm. The default value is 0.0.0.0.
RTSP port Specifies the RTSP port. The default value is 554.
Video encoder type Specifies the video encoder used.
Options include: H.264 and MPEG4
Defining a recording schedule
You can define a recording schedule for the camera in the “Schedule record”
window. The recording is saved on to the SDHC card in the camera. Although all
recordings are saved on a DVR, the camera’s SDHC card provides a backup in
case of network failure, for example.
The selected recording schedule applies to all alarm types.
You will be prompted to reboot the camera after making any schedule
modifications.
Post-event recording times
The post-event record time is used if you have the motion detection enabled.
When a motion alarm is cleared, the camera will continue recording based on the
value specified in this option. Options include: 5 (default), 10, 30 seconds, 1, 2, 5,
and 10 minutes.
To define a recording schedule:
1. In the “Channel parameters” folder click the Schedule record subfolder to
open its window.
2. Click the Enable Recording box to enable recording.
Note: To disable recording, deselect the option.
3. Select the post record time from the drop-down list.
4. Select whether the recording will be for the whole week (All day recording) or
for specific days of the week (Section recording).