Interlogix DVR 41 User Manual - Manual (Page 12)

1BChapter 2: Installation
6 TruVision DVR 41 User Manual
Each PTZ camera must be set up individually. For information on configuring
PTZ dome camera settings, see Chapter 6, “Controlling a PTZ camera” on page
43.
Connecting a TVR 41 to a PTZ dome camera and a
keypad
Use the input/output box that is supplied with the keypad to connect a keypad to
the TVR 41. The keypad can be connected to a PTZ camera for local control or
for control over the network.
See Figure 2 below for the preferred setup. Any PTZ dome camera can be
controlled as the DVR is doing the PTZ protocol translation. However, this setup
provides only limited dome configuration.
Figure 2: Connecting a keypad to the TVR 41 for control of a PTZ dome camera over the
network
Configuring the PTZ protocols for Interlogix cameras
Before the PTZ dome cameras are assembled in their housings, set their
protocol and address DIP switches for the TVR 41. See Table 2 on page 7 for
different Interlogix PTZ dome camera settings.
If you are using PTZ dome cameras from another company, please refer to their
configuration instructions.