Selecting a camera using the keypad, Controlling a camera – Interlogix DVR 41 User Manual User Manual
Page 167
20BAppendix D: Port forwarding information
TruVision DVR 41 User Manual
161
Selecting a camera using the keypad
The TVR 41 can support up to 16 analog cameras. To be able to control up to 16
cameras using the keypad, you may need to change the number of TVR 41
camera inputs controlled by the keypad. The default number of TVR 41 camera
inputs controlled by the keypad is 16.
To change the number of TVR 41 camera inputs controlled by the keypad:
1. Hold down the Enter button (
) until a beep sounds and then enter the
following code:
1 4 7 6.
Push the
seq
button to confirm.
2. Scroll through the menus with the
button until this menu appears:
3. Enter the DVR address to be configured and press
.
4. Scroll through the menus with the
button until this menu appears:
5. Press the up/down arrow buttons to navigate to SYM DVR.
6. Scroll through the menus with the
button until this menu appears:
7. Press the up/down arrow buttons to navigate to 32.
8. Repeat steps 3 to 7 for each DVR address in the keypad.
Controlling a camera
When setting up and controlling your cameras in zone mode, refer to Table 23
below for the list of default PTZ addresses associated with a zone ID. This value
is automatically populated in the system. You can modify the PTZ address in the
PTZ menu to meet customer requirements (see “Configuring PTZ settings” on
page 43).
Table 23: Default PTZ camera addresses by zone ID
Camera
input
Zone ID of TVR 41
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
1
0
32
64
96
128 160 192 224 256 288 320 352 384 416 448 480
2
1
33
65
97
129 161 193 225 257 289 321 353 385 417 449 481
3
2
34
66
98
130 162 194 226 258 290 322 354 386 418 450 482
4
3
35
67
99
131 163 195 227 259 291 323 355 387 419 451 483