Interlogix DVR 41 User Manual - Manual (Page 43)

4BChapter 5: Live view
TruVision DVR 41 User Manual 37
Changing the camera sequence
The cameras are sequenced in numeric order by default. You can change the
sequence order of the cameras for all monitors.
You can switch the channel of a camera with that of another camera in the
system. This lets you, for example, have the images of camera 1 appear on
channel 10, and the images of camera 10 appear on channel 1. This feature is
useful when you want to watch the sequence of images from specific cameras so
that they are next to each other on-screen.
See Figure 17 below. Each video tile displays both the order of the camera in the
sequence and the camera number.
Figure 17: Camera layout and sequence screen
Multiview layout selection bar
Camera order in the
sequence
Camera number selection
To set the camera sequencing:
1. Click the Display Mode Settings icon in the menu toolbar.
2. Select Layout > View .
3. From Video Output Interface , select the desired monitor from the drop-down
list.
4. From the multiview layout selection bar, select the desired multiview layout.
5. Select the video tile of the camera whose order you want to change. The
selected tile is highlighted green.
6. In the selected tile, select the new camera sequence order by scrolling the
through the list of available camera numbers.
Note: “X” means that the camera is not displayed.
7. Click Apply to save the settings.
8. Click Back to return to live view.
Camera sequencing for alarms and events
You can select which monitor is used to sequence alarm and event cameras in
full screen mode. Normally this is the spot monitor. When an alarm or event
occurs, the selected monitor will sequence through the alarm/event cameras