Corinex Global Powerline Router - Manual (Page 106)

The example in Figure 7.1 shows the IP address of your Ethernet adapter as
10.101.2.38. Your computer may show something different.
7.2 For Windows NT, 2000 and XP
The following steps show an alternative way of obtaining the MAC address
and IP address for your Ethernet adapter.
1. Click on Start and Run. In the Open field, enter cmd. Press the Enter
key or click the OK button.
Fig. 7.2 Running ipconfig
2. In the command prompt, enter ipconfig /all (Fig.7.2). Then press the
Enter key.
3. Write down the Physical Address as shown on your computer screen
(Figure 7.2); it is the MAC address for your Ethernet adapter. This will
appear as a series of letters and numbers. The MAC address/Physical
Address is what you will use for MAC Address Cloning or MAC Filtering.
The example in Figure 7.2 shows the IP address of your Ethernet adapter as
10.101.2.122. Your computer may show something different.
Note: The MAC address is also called the Physical Address.
When entering the information using the Router’s web-based utility, you
will type the 12-digit MAC address in this format, XX:XX:XX:XX:XX:XX
without the hyphens for MAC Filtering (Fig.3.17) on MAC Adress Cloning
(Fig.3.9).
103
For Windows NT, 2000, and XP
Corinex Powerline Router User Guide