Corinex Global Powerline Router - Manual (Page 77)

4. Click Next again to program the Corinex Powerline Router with the
new encryption key. This will take a few seconds. The next screen will
look similar to the following screen. The white box will list the MAC
addresses of all other installed powerline devices on the network that are
programmed with your chosen network password. If no other devices have
been programmed, the list will be empty. If you use also other than Corinex
HomePlug certified devices in the network, these devices may be set at
the default status. This default setting makes sure that HomePlug devices
find each other in a network and connect and communicate automatically
with each other. In order to generate your private and secure network,
all HomePlug certified devices in the network must be set to the same
network encryption key, either at the default key "HomePlug" or your own
selection.
Fig.3.40 Configured devices
The adapter with the MAC address 00:0B:C2:00:0F:93 acts as local device
in the network and identifies the devices shown under Devices Address in
the window as belonging to the network. The function and performance
of the devices between the local device / adapter 00:0B:C2:00:0F:93 and
the devices identified in the network is displayed in the window under
Connection Quality.
5. All devices in your network must be programmed with the same
network encryption key. Run this utility on all computers with a powerline
networking device attached. If you have a powerline device that is not
normally connected to a computer, it must first be connected to a
computer and set up with a network encryption key.
74
Powerline Setup through the Ethernet Interface
Corinex Powerline Router User Guide