Vertical Communications SCS 8324F - Manual (Page 80)

Other Features GCA70-245
70 Comdial August, 03
7.2 Volume Control
7.2.1 SETTING CURRENT VOLUME LEVEL
The volume control on your telephone is a multipurpose control you
can use to set the volume (loudness) of the ringer, the speaker, the
handset, the headset, and the group listening mode.
• There are four ringer
loudness levels (plus an off
position). Set these levels as
follows:
—While your telephone is on-hook
and idle, PRESS the VOLUME UP
OR VOLUME DOWN button once
for each change in loudness you desire. The ringer sounds once for
each change as an example of the current setting.
• There are eight speaker loudness levels. Set these levels
for the current call as follows:
—While on a call and in speakerphone mode, PRESS the VOLUME UP
OR VOLUME DOWN button once for each change in loudness that
you desire.
• There are at least eight handset loudness levels that you
can set for the current call as follows:
—While on a call and in handset mode, PRESS the VOLUME UP OR
VOLUME DOWN button once for each change in loudness that you
desire.
NOTE: If you set the ringer to the OFF position, your telephone
sounds a short ring burst once for each call you receive at your
station while the ringer is off.
NOTE: When the call ends, the system resets the loudness of all future
calls to the programmed (default) setting. For instructions in setting
your speakerphone’s default volume, see Default Volume Control section
in the system specific Advanced Features chapter.
Impact SCS Volume Buttons