Vertical Communications SCS 8324F - Manual (Page 92)

Other Features GCA70-245
82 Comdial August, 03
• Program the enable/disable buttons (at any blank
programmable button location) as follows:
1. PRESS INTERCOM.
2. DIAL **1.
3. PRESS programmable button.
4. DIAL a feature code
94 = Headset Button,
95 = External Ringer Button,
96 = Tape Recorder Button,
97 = External Pager Button.
5. PRESS TRNS/CONF.
6. REPEATEDLY PRESS programmable button AND DIAL separate
codes until all four buttons are programmed, OR PRESS SPEAKER
to end.
• To use a feature button,
1. PRESS desired button to enable mode. The display denotes the fea-
ture and shows it to be enabled.
2. To disable any active mode, press the corresponding feature button to
alternate off.
CAUTION
With the exception of a headset microphone,
do not connect the audio output of any external
device to the auxiliary jack. Also, do not connect the tip
and ring leads of a telephone line to the auxiliary jack. Do not connect
any devices to the auxiliary jack other than those mentioned above