Compaq 340622-002 - Manual (Page 16)

2-4 Drive Installation
Compaq SLR Tape Drive User Guide
IMPORTANT: Do not use SCSI ID = 7. This is reserved for SCSI controllers.
Table 2-1
Selecting the SCSI ID
SEL2 SEL1 SEL0 SCSI ID
OPEN OPEN OPEN 0
OPEN OPEN CLOSED 1
OPEN CLOSED OPEN 2
OPEN CLOSED CLOSED 3
CLOSED OPEN OPEN 4
CLOSED OPEN CLOSED 5
CLOSED CLOSED OPEN 6
CLOSED CLOSED CLOSED 7
NOTE: In the above table, “CLOSED” indicates that a jumper has been installed.
Installing the Drive
Refer to the documentation supplied with your system for specific instructions
on obtaining access to the removable media bay where you intend to install
your drive.
WARNING: : To reduce the risk of electric shock or damage to the
equipment, disconnect power from the server by unplugging all power cords
from either the electrical outlet or the server.