Clarion VRX938R - Manual (Page 13)

VRX938R
17
English
Owner’
s manual
9. OPERATIONS
Basic Operations
Note: Be sure to read this chapter referring to the front diagrams of
chapter “2. CONTROLS” on page 5 (unfold).
When the unit is turned on, starting and stopping
the engine with its volume raised to the maximum
level may harm your hearings. Be careful about
adjusting the volume.
CAUTION
Turning on and off the power
Note:
• Be careful about using this unit for a long time with-
out running the engine. If you drain the car’s battery
too far, you may not be able to start the engine and
this can reduce the service life of the battery.
1. Press the [FUNC] button.
2. The illumination and display on the unit light
up. The unit automatically remembers its last
operation mode and will automatically switch
to display that mode.
3. Press and hold the [FUNC] button for 1 sec-
ond or longer to turn off the power for the unit.
Note:
• About the “SYSTEM CHECK”
The confirmation of connected equipment must be
performed for this unit only when the wiring con-
nection is complete and power is turned on to the
unit first. When the power is supplied, “SYSTEM”
and “PUSH PWR” appear alternately in the display.
Press the [FUNC] button, the system check starts
inside the unit. When “COMPLETE” appears, press
once again the [FUNC] button.
Selecting a mode
1. Press the [FUNC] button to change the mode
of operation.
2. Each time you press the [FUNC] button, the
mode of operation changes in the following
order:
Radio mode ➜ DAB mode ➜ CD mode ➜
DVD video mode ➜ CD changer mode ➜ MD
changer mode ➜ DVD changer mode ➜ TV
mode ➜ VISUAL mode ➜ Radio mode...
∗
External equipment not connected with CeNET
is not selected.
Note:
• Use this unit after starting the engine.
Adjusting the volume
Operate the [VOL] button in the direction of the +
(up) or – (down) to adjust the volume;
+ : Increases the volume.
– : Decreases the volume.
∗
The volume level indicated in the display is in a range
from 0 (minimum) to 33 (maximum).
While driving, keep the volume at a level at which
external sounds can be heard.
CAUTION
Switching the display
When the panel is closed:
Press the [DISP] button to select the desired dis-
play.
Each time you press the [DISP] button, the dis-
play switches in the following order:
Notes:
• Once selected, the preferred display becomes the
default display. When a function adjustment such
as volume is made, the display momentarily
switches to that function’s display, then returns back
to the preferred display several seconds after the
adjustment.
• If a title has been input, it is shown in the SUB dis-
play. If no title has been input, “---------” appears in
the display. To input a title, refer to the subsection
“Entering titles” in “Other Functions” section.
• For CD, MD and TV, some special characters of the
title, the PS name of the RDS, and the DAB service
label will not be displayed on the Information Panel
of the DCP. In this case, those characters will only
be left blank.
• When CT data is not received, “CT--:--” appears in
the display.
MAIN Display
SUB Display
Clock Time (CT) Display
MAIN Display
ACC or engine
ON position