Clarion VRX938R - Manual (Page 14)

18
VRX938R
English
Owner’
s manual
Showing a mode display
When the panel is open:
Touch the menu screen switching touchkey when
the main screen is being displayed to show the
menu screen.
Touch the Title List Select key (--- SELECT) on
the menu screen to show the Title List display.
In the Title List display, the titles of items stored in
the [DIRECT] buttons 1 to 6 are listed.
∗
In the RDS tuner mode, a PS name is displayed.
∗
In the DAB mode, a service label is displayed.
Opening and turning the display
20˚
20˚
Basic Operations
WARNING
• To prevent the battery from going dead,
operate this unit with the engine running,
if possible.
• When the liquid crystal panel is operat-
ing, be careful not to get your hand or fin-
ger caught between the panel and main
unit or the instrument panel of the car.
Standing up the liquid crystal panel
1. When the power is turned off, press the [FUNC]
button to turn on the power.
2. Press the [OPEN] button and the liquid crystal
panel comes out and stand up automatically.
∗
While the liquid crystal panel is opening or clos-
ing, the LED blinks.
Note:
• If the liquid crystal panel stops in the middle of its
operation, press the [OPEN] button to house the
panel and press the button again to stand it up. The
unit enters the same display mode as the display
was turned off the last time.
Adjusting the angel, etc. of the
liquid crystal panel
The angle of the liquid crystal panel or protruding
amount of the panel from the mounting surface
can be adjusted depending on the mounting angle
of the unit or light coming into the car.
To adjust the angle
Every time the [TILT] button is pressed, the liquid
crystal panel tilts forward or backward at up to
about 20 degrees. The adjusted angel is stored in
memory.
Note:
• Do not move the liquid crystal panel by hand.
To adjust the slide position
Press and hold the [TILT] button and release when
a beep is heard.
The liquid crystal panel slides forward or back-
ward. The adjusted slide position is stored in
memory.
Housing the liquid crystal panel
Press the [OPEN] button and the liquid crystal
panel is housed automatically.
Note:
• When leaving this unit unused for a long period of
time or leaving your car, be sure to house the liquid
crystal panel into the main unit.