Country Flame CF-04 - Manual (Page 22)

Version 2.0e 22
STOVE SPECIFICATIONS
TABLE 2 shows the physical dimensions of the Crossfire product.
CROSSFIRE DIMENSIONS
(IN INCHES)
STOVE HEIGHT (At Front) 22.5“
STOVE DEPTH (From Shroud) 14.0“
STOVE WIDTH (Rear) 26.0“
STOVE WIDTH (At Shroud Mount) 25.5“
STOVE WEIGHT (empty) 220 pounds
SHROUD WIDTH, (standard) 42.0”
SHROUD HEIGHT (standard) 30.0”
SHROUD WIDTH, (oversized) 48.0”
SHROUD HEIGHT (oversized) 32.5”
TABLE 2: CROSSFIRE, CF-O4 SPECIFICATIONS
ELECTRICAL REQUIREMENTS
The Crossfire Model CF-04 requires a code compliant grounded 120 volt, 15 ampere, and 60 hertz electrical
outlet. The Crossfire utilizes only a fraction of the 15 amperes rating of a code compliant outlet but it is
strongly recommended that a dedicated circuit (versus a branch electrical circuit) be provided for the stove to
ensure no interference from other electrical appliances.
GOLD DOOR CARE
All Crossfire plated doors and trim (gold or nickel) should be wiped down BEFORE THE FIRST FIRE to
prevent potential permanent damage to occur to plating. For general cleaning, use a dry cloth and wipe the
plated surface to ensure the luster and beauty lasts a lifetime. Always use an approved glass cleaner (i.e.
Windex, Glass Plus) and a lint free soft cloth to polish the doorframe. DO NOT use abrasives, like steel
wool, brass polish, or cleaners, like Comet. Improper cleaners can permanently scratch the finish. A
damaged door can be returned to Country Flame for refinishing but repair is expensive. Proper care of the
Crossfire plated door and other plated trim will ensure these parts will survive a lifetime of use. A painted
Crossfire door requires no specific care.
OPTIONAL FEATURES
There is an ever growing list of options for Country Flame stove products, including the Crossfire. Contact
an authorized Country Flame dealer for more information.
OPTIONAL THERMOSTAT OPERATION
A thermostat option is available for the Crossfire. With the optional thermostat installed, the Crossfire can be
turned on and off based on a preset temperature according to the customer’s desire.
CROSSFIRE IS COLD
• Start up the Crossfire by first installing pellets into the burn pot.
• Hold the Intelli-Choice Control Board on/off switch until the power light turns green and the igniter
light begins to slowly blink on and off.
• Once a pellet fire has been established, hold the Intelli-Choice Control Board on/off switch until the
auger light blinks rapidly on and off. Release the Intelli-Choice Control Board on/off switch.
• If the #3 heat setting lights up, the Crossfire will begin feeding corn. Ensure proper air setting for the
temperature set. If the auger light goes back to blinking on and off slowly, wait until the stove warms
up further and then repeat the process until Heat Setting #3 is obtained.
CROSSFIRE IS HOT
• If the stove is set to a heat setting greater than 1 when the thermostat calls for heat, the Intelli-Choice
Control Board will remember this setting and return to this setting any time heat is called for by the
thermostat.