Country Flame CF-04 - Manual (Page 28)

Version 2.0e 28
6. The installer should now place the trim (black or gold as purchased) around the edges of the
shroud panels. Once installed, if the bottom left or right side trim pieces want to pull away
from the shroud panel, a small amount of RTV (silicone) may be used on the backside of the
shroud panel to hold the trim in place. Close and secure both Crossfire side access doors.
Installation is now complete and the Crossfire can be moved into its final location. As the
Crossfire is slid back into the hearth, it is important not to push to hard and bend the shroud due
to excessive pressure but at the same time, ensure enough pressure is applied between the
hearth face and the shroud trim to avoid unwanted vibration during operation. FIGURE 11h
shows how the shroud should look on the Crossfire once installation is complete.
FIGURE 11h: CROSSFIRE SHROUD (shown with optional gold trim)