Country Flame CF-04 - Manual (Page 33)

Version 2.0e 33
Do not violate minimum clearances with approved thermal barriers. Manville’s CERAFORM 126 is
an example of an approved insulated wall protector. This product has a K equal to .27 and is a half-
inch thick. Total thermal resistance should exceed 1.5 for any material used to ensure proper thermal
protection of a combustible wall.
MOBILE HOME STOVE ATTACHMENT
1. Install combustion air to the back of the Crossfire in all mobile home applications. The other end of
the combustion air tube is to be installed through the mobile home floor or a wall. Ensure that snow
or other material cannot prevent fresh air from entering the duct located outside the mobile home.
2. The Crossfire must be secured to the floor of the mobile home, as shown in FIGURE 14 and must be
properly grounded to the steel frame of a mobile home.
3. Install a mesh screen or an approved fresh air cap on the outside of the mobile home combustion air
tube. This cap will keep foreign material, birds, or small animals out of the fresh air system. Do not
use mesh screen from windows as it has too small a hole.
4. If operation of the Crossfire stove causes room air starvation, dangerous fumes can be sucked into the
mobile home from other vented appliances. WARNING: DO NOT INSTALL ANY CROSSFIRE
PELLET BURNING STOVE IN A SLEEPING ROOM. Air starvation usually occurs: (a)
because the combustion air intake is blocked, (b) because the stove door is left open or does not seal
properly, or (c) due to strong exhaust fans being operated inside the mobile home. Always ensure
that fresh air intake systems remain unblocked and ensure free fresh airflow. Contact your local
Country Flame dealer for annual inspections.
FIGURE 14: MOBILE HOME PEDESTAL INSTALLATION
MOBILE HOME FLOOR PROTECTION
1. A mobile home floor must be protected against stray sparks, radiant heat build up, or from
damage during general use.
2. This floor protection must meet certain minimum requirements as a thermal barrier. Calculations
are provided in this manual for determining if a floor protector meets minimum requirements for
a mobile home installation.