Keri Systems LC-208 Wiegand Elevator Control - Manual (Page 2)

Wiegand Elevator Control Panel
1530 Old Oakland Road, Suite 100 01879-002 Rev. C
San Jose, CA 95112 USA
(800) 260-5265 (408) 451-2520 FAX (408) 441-0309
Web: http://www.kerisys.com E-mail: [email protected]
Page 2 of 24
Quick Start Guide
LC-202W/LC-208W
• User card presentation to the reader is critical. To ensure that all controllers have the opportunity
to respond to a card read, the card must be presented to the reader for a greater period of time
(perhaps up to 2 seconds depending upon the length of the cable run and the number of
controllers attached to the network). This allows all antenna inputs on all controllers the time
necessary to respond to the card.
2.0 Hardware and Software Operating Requirements
All standard hardware and software requirements for Doors32 software apply (refer to the Doors32
Users Guide – P/N 01821-002). To support elevator control, the following additional software and
firmware requirements must be met.
• The Doors32 software must be at revision 3.42 or greater.
• The controller firmware must be at revision 6.3.42 or greater.
3.0 Specifications
3.1 Unit Dimensions
• LC-200W Controller PCB with or without SB-200 Satellite Board
-
7.00 inches high by 6.00 inches wide by 1.75 inches deep, including wiring connectors
- (17.78 cm by 15.25 cm by 4.45 cm)
• LC-200W Controller PCB with an LCD-1 Alpha/Numeric Display
-
8.25 inches high by 6.00 inches wide by 1.75 inches deep, including wiring connectors
- (20.95 cm by 15.25 cm by 4.45 cm)
• LC-202W Enclosure
-
9.70 inches high by 8.20 inches wide by 2.60 inches deep
- (24.64 cm by 20.83 cm by 6.60 cm)
• LC-208W Enclosure
-
18.50 inches high by 15.25 inches wide by 4.00 inches deep
- (47.00 cm by 38.75 cm by 10.20 cm)
3.2 Operating Temperature and Humidity Range
• 0°F to 140°F (-18°C to 60°C)
• 0% to 90% Relative Humidity, non-condensing
3.3 Power Requirements
• 12 VDC @ 750 mA for the LC-202W panel
• 12 VDC @ 3 A for the LC-208W panel