KERN & SOHN ABT 220-5DM - Manual (Page 69)

ABT-BA-e-1312 69
15.5.4 Stop bit settings
1. The display changes from “io.S:****” to “S-S1”. Pressing the [CAL] key changes the
display. The standstill display ( ) marks the current setting.
Display during setting
S-S1 S-S2
Setting specifics
Stop bit, 1 bit Stop bit, 2bit
2. Confirm your desired setting by pressing the [TARE] key.
3. To return to "io.S:****", press the [ON/OFF] key.
15.5.5 Input-output data format settings
1. The display changes from "io.F:****" to " F-dF1". Pressing the [CAL] key changes
the display. The standstill display ( ) marks the current setting.
Display during setting
F-dF1 F-dF2 F-dF3 F-dF4
Setting specifics
Data format 1.
Standard format Data format 2.
Not documented Data format 3.
Not documented Data format 4.
Not documented
2. Confirm your desired setting by pressing the [TARE] key.
3. To return to "io.F:****", press the [ON/OFF] key.
Note
: When set to data format 2, the balance will always send a process result
against commands from the computer.
15.5.6 Handshake settings
1. The display changes from "io.H:****" to " H-oFF". Pressing the [CAL] key changes
the display. The standstill display ( ) marks the current setting.
Display during setting
H-oFF H-Soft H-HArd H-tr
Setting specifics
No handshake
Software
handshake
Hardware
handshake
Timer
handshake
2. Confirm your desired setting by pressing the [TARE] key.
3. To return to "io.H:****", press the [ON/OFF] key.