LAARS Pennant PNCP - Install and Operating Manual User Manual

Page 19

Advertising
background image

Pennant Pool Heater

Page 19

The service light will turn out, and the heater will

resume normal operation. Please note that if the heater

is equipped with a low water cut off there will be a

brief delay while the LWCO completes a self-check.

6.6 Spring and Fall Operation

Stand-by Service

Turn the thermostat down to approximately 70°F

(21°C). This will prevent the pool and surrounding

ground from becoming chilled and permit the pool to

be raised to swimming temperature in a shorter length

of time. Do Not Operate below 60°F (16°C).

6.7 Winter Operation

Complete Shutdown

1. See Section 6.4

2. If the heater is not protected from freezing

temperatures, it should be completely drained

before the first frost. Drain the heater by

removing the plug at the end of the inlet/outlet

header casting. Also, remove the small plug at

the bottom of the pump housing. Do not replace

either plug until the time that refilling is desired.

The heater must be level for complete draining.

When compressed air is used to blow out lines,

it is still necessary to follow these directions.

Because of the potential for electrical power

failure or pump failure, freeze protection should

never be accomplished by operating the pool

heater and the filter pump. Either of those failures

will potentially allow a freeze up and cause

damage to the heater and the attached system.

3. Improper use of the heater: The Laars PNCP

pool heater is not designed for continuous use as

a “anti-freezing” device for pools. Operating the

heater at low water temperatures will damage the

heat exchanger.

6.8 To Restart the Pennant

If drained, follow Section 6.2 in this manual for

proper filling and purging.

1. Switch off the main electrical disconnect switch.

2. Close all manual gas valves.

3. WAIT FIVE (5) MINUTES.

4. Set the pool aquastat to its lowest setting.

5. Open all manual gas valves.

6. Reset all safety switches.

7. Set the temperature controller to the desired

temperature setting and switch on electrical

power.

8. Burner will go through a prepurge period and

ignitor warm-up period, followed by ignition.

6.9 Therapeutic Pools (Spas)

Therapeutic pools or “spa” pools are usually

piped and controlled so that very warm or hot water,

often with air injection, is forced at high velocity

into a confined area of a swimming pool or into a

small separate pool. For the purposes of this manual,

any application in which the water temperature is

maintained above 85°F (30°C) is considered a spa.

SPECIAL SET-UP AND OPERATING

PROCEDURES APPLY TO SPAS.

1. Models PNCP1000 and larger should not be used

for spas due to their higher temperature rises.

2. To ensure that the spa inlet does not exceed 104°F

(40°C), the spa filter pump must circulate water

at the minimum flow rates shown in Table 9.

NOTE: Maximum Spa Temperature Is Assumed To Be

100°F (38°C).

3. Spas are excellent for relaxation, body-

conditioning and for arthritic and rheumatic

problems, but can be hazardous.

WARNING

The U. S. Consumer Product Safety Commission

has warned that elevated temperatures in spas and

hot tubs can be hazardous. Follow these “Safety

Rules for Hot Tubs:”

• Spa or hot tub water temperatures should never

exceed 104°F (40°C). A temperature of 100°F

(38°C) is considered safe for a healthy adult.

Special caution is suggested for young children.

• Drinking of alcoholic beverages before or during

hot tub use can cause drowsiness, which could

lead to unconsciousness and subsequently lead

to drowning.

• Pregnant women beware! Soaking in water

above 102°F (39°C) can cause fetal damage

during the first three months of pregnancy

(resulting in the birth of a brain-damaged or

deformed child). Pregnant women should stick

to the 100°F (38°C) maximum rule.

• Before entering the spa or hot tub, users should

check the water temperature with an accurate

thermometer; spa or hot tub thermostats may

err in regulating water temperatures by as much

as 4°F (2°C).

• Persons with a medical history of heart disease,

circulatory problems, diabetes or blood pressure

problems should obtain their physician’s advice

before using spas or hot tubs.

• Persons taking medications which

induce drowsiness, such as tranquilizers,

antihistamines or anticoagulants, should not

use spas or hot tubs.

Advertising