LAARS Mascot ll LMC - Install and Operating Manual - Manual (Page 9)

Mascot II Boilers and Water Heaters Page 7
Figure 4. Locating the Appliance.
Figure 5. Mounting Detail.
Figure 6. Wall Template (not to scale). Full-size template is
included with the unit.
Zero clearance is allowed to combustible surfaces.
However, the above minimum service clearances are
strongly recommended.
Closet installations require minimum air ventilation
(see Section 3).
Note: Mascot II
bracket and wall
bracket are
purposely offset.
NOTE: Mascot II models include 16" on-center mounting
holes on upper rear of boiler jacket. These holes are
not identified on the mounting template. If mounting
conditions are appropriate, the installer may opt to
use this alternative method in lieu of the standard wall
bracket depicted. Installer must provide appropriate
mounting/anchoring hardware.
(Minimum)