LABEC AA-17BS - Manual (Page 12)

5.6 Cycle end
After sterilization the display will show as per fig 5-5 and an alarm
will sound. The door can now be opened and the sterilized
instruments unloaded.
Caution: If you decide to stop using the autoclave for a while, please
turn the main power switch off, or unplug the power cord should you
not want to use the machine for a long time.
Caution
Fig5-4
Fig5-5
SEA Series Steam Sterilizers
Operation manual 8
0.05 Bar 83.5 C
Open door
The end
5.4 Start Selected Cycle
Close the door after loading the autoclave and press START key to
begin the cycle. After 0.5 seconds the electrical lock will engage.
If the electrical lock did not close correctly the autoclave will display a
door fault. The sterilization cycle will only start after the door is
locked successfully (See fig 5-4).
5.5 Stopping a Cycle
To abort a cycle during sterilization press the Start/Stop key for 3
seconds.
There are two different exit modes:
1.If you press the button for 3 seconds during Pre-heating Phase,
Pre-vacuum Phase or Sterilization Phase it will enter into an
Exhaust Phase. After 3 minutes drying the whole cycle will end.
If you need to end the cycle immediately press the Start/Stop
button for 3 seconds again.
2.Press the Start/Stop button for 3 seconds during drying Phase to
end the cycle immediately.
1.When the Water Level Low alarm sounds refill the unit with distilled water.
2.When the autoclave is refilled the waste water tank should be emptied via the outlet below the On/Off switch
(See section 9.2, fig-9.4).
3.Always use the tray holder to load or unload the tray with instruments in it in order to avoid burning
injuries.
4.Never try to open the chamber door if and when the pressure display doesn't show 0.0 .
5.It is suggested that chemical indicator or bio-indicator be used for each and every cycle to ensure the reliability
of each sterilization cycle run.
To ensure correct operation of the autoclave: