LABEC M-MIA-CC - Manual (Page 64)

Ultrasonic milk analyser
Operation manual 23.08.10 62/98
Raw Test - test for weight scales control. Used mainly in production
conditions.
Calibration – serves for scales calibration (if there is deviation noticed).
For the purpose you have to have 2 standards of weight, for example 5 and
50 kg.
After starting the following is dispalyed:
Weight Scale Cal
Put Low Weight
Weight =zz.z
Using the buttons Up, Down, Enter (as it is done when calibrating the rest of
the milk analyser’s options) enter the weight of the lighter standard of weight,
in our case 05.000. After it, on the bottom line of the display appers:
ADC=xxxx.x Set
where:
хххх.х – calibrating data from the scales.
The operator waits for the value to be shown and presses the button below
the word Set. The same procedure is repeated with the heavy standard
weight, for. example 50.000 kg. After the value is shown and pressing the
button Set, a message for completed calibration is displayed. Scales are
ready for work.
Measure – Off Line measuring mode, i.e. the analyser is used as
universal scales. In this mode periodically control of the accuracy of the
scales with standards of weight is needed.
On Line En/Dis – allows / forbids On Line weight scales work
(automatically transferring the kilograms measured milk from the scales to the
analyser, after setting the deliverer’s number). If option Enable is chosen,
follow the way of work described above. If not, then the operator has the
possibility to enter manually liters and number of the every deliverer.
9.9. Working with embedded report system for generating and making
reports – Report System (option).
On customer’s request hardware could be embedded in the analyzer,
allowing results from 1000 measurements to be recorded and kept as a
record. On the base of these recorder measurements different reports are
made. Making results’ archives is made automatically after the measurement
is finished, and is controlled via the following menus system: