LABEC M-MIA-CC - Manual (Page 89)

Ultrasonic milk analyser
Operation manual 23.08.10 87/98
By pressing the button Exit, the operator may exit the program and to pass
towards another menu.
10. pH En/Disable
Serves for enabling/disabling the pH measuring during normal work of the
analyser - On line. After starting it the display shows:
pH Measuring
XXX
No OK Yes
Where:
XXX is the current situation of the working mode. By pressing the buttons
below the corresponding inscriptions it could be changed, as Yes – means
that during normal work of the analyser – measuring the rest of the
parameters, pH will also be measured. If No is chosen, then pH is not
measured.
11. pH U Display
Serves for allowing/forbidding the value of the pH probe voltage during pH
parameter measuring. After starting it the display shows:
PHUDisplay
XXX
No OK Yes
Where XXX is the current state of the displaying mode. By pressing the
buttons below the inscriptions it could be changed, as Yes – means that
during pH measuring the voltage of the pH probe will be shown.
If No is chosen, it will not be shown. It refers to both of the measuring modes.
12. pH test
serves for testing the measuring system in production mode.