Canon 800II - Manual (Page 24)

Chapter 2 Specifying the Scanner Settings
24
When you select Batch mode, always ensure that OFF is selected in
the SemiAuto setting. Selecting ON as the SemiAuto setting disables
the Batch mode setting. If you want to use Batch mode when the
SemiAuto setting is ON or if you want to use Batch mode from FS Con-
troller I, select Batch mode from the keyboard supplied with the FS
Controller. Refer to your FS Controller user’s manual for details.
Image Rotation
Rotates the scanned image 90 ° to the right (clockwise) for printing.
If the Add on function ( ➝ P.26) is selected, the image is rotated 90 ° and printed
after the text etc. has been imprinted on the image.
Detect Image Size
When this option is enabled, the Scan Size and Trimming/Border settings are also
enabled and Page Size in the scanner settings is disabled.
(
➝ “Selecting the Scan Size” and “Trimming/Border settings” in the Microfilm Scan-
ner 800II Instructions)
Add on
Check this option to imprint the information specified in the Add-on setting ( ➝ P.26)
on the scanned image.
Semi Auto
If scanning is started with this option enabled, the Semi Auto key on the scanner’s
operation panel glows green and the Start key switches to the ready state. Check
the scanned image and then press the Start key to perform the scan. After you
have checked the scanned image, press the Start key to begin scanning. If you
switch Semi-Auto mode on, the [Detect image size] option is also set to ON.
Margin Scanning
Adjusts the margins (top, bottom, left and right) for the specified scan size.
To adjust the margins, click the Enable checkbox and specify a setting between –10
(reduces the scanned area by 10 mm) and +10 (enlarges the scanned area by 10).
For example, to slightly enlarge the scanning area so that the edges of the docu-
ment are not cropped, specify a positive setting. To slightly reduce the scanning
area and avoid creating a black frame around the image, specify a negative setting.
These margin settings are also applied in image size detection.
AE Adjustment
This is a fine adjustment for the automatic brightness and contrast adjustments
and is enabled when automatic adjustment is selected in the Brightness setting.
AE adjustment can be set to any value between 1 and 17.
Sharpness
This setting is valid when the image mode setting is Black and White, Black and
White-Fine or Black and White-Picture. It sets the level of text outline enhance-
ment and the softening of image gradations in photographs, etc. Values between
1 and 5 can be selected as the sharpness setting.
IMPORTANT