Canon 800II - Manual (Page 39)

39
Chapter 3 Using the Scanner
3
Using the Scanner
Saving images when film is scanned repeatedly (consecutively)
When film is scanned repeatedly (consecutively) and the images are saved
in TIFF format, multiple pages of images are saved as a single TIFF file (multi-
page TIFF).
If the images are saved in the BMP, JBIG or JPEG format, each page in the
document is saved to the specified destination folder as a separate file. The
files are named using sequential numbers (“0001”, “0002”, etc.) automatically
appended to the specified file name. (Eg. When the pages are saved as BMP
files with the “scan.bmp” file name, files called “scan0001.bmp”,
“scan0002.bmp”, etc. are created.)
If you use the New File function or File Separator function to separate files,
folders with sequential numbers (“0001”, “0002”, etc.) are automatically cre-
ated for each separator and the images are saved into those folders.
4
Select the [Separator] setting. (Only when an FS Controller III
is used)
• None
No file separators are used.
• File Mark
File marks on the film are used to separate files.
• Batch Mark
Batch marks on the film are used to separate files.
• File/Batch Mark
File and batch marks on the film are both used to separate files.
File separators can be selected when the FS Controller III is used. They act
as triggers for file separation during continuous scanning. Refer to the FS
Controller III Instructions for details.
5
Click [Start Scanning].
The screen image is scanned.
In Semi-auto mode, the Start key turns green indicating the ready state. Check
the scanned image and then press the Start key to perform the scan.
NOTE
NOTE
NOTE