Canon 800II - Manual (Page 27)

27
Chapter 2 Specifying the Scanner Settings
2
Specifying the Scanner Settings
(Input) (Add on result)
CANON[00001] CANON 00001
<Time>
To add the time that the document was scanned, type “\TIME”.
The time is added as an 8-digit number (including colons) in the 24-hour clock for-
mat, as shown in the examples below.
(For 4.28.30 pm)
(Input)
(Add on result)
\TIME 16:28:30
<Date>
To add the date that the document was scanned, type a combination of Y (year), M
(month) and D (day) to give “\MDY”, “\DMY” or “\YMD”.
The date is added as a 10-digit number, as shown in the example below. Slashes are
used as separators between the year, month and day.
(For January 20, 2000)
(Input)
(Add on result)
\YMD 2000/01/20
<Arrows>
To add an arrow, type one of the following:
(Input) (Add on result)
\u
\d
\l
\r
<Film Address>
When the FS Controller III is used as the carrier, this option adds the film address of
roll film detected by the FS Controller III.
To add the film address (batch, file and page), type “\A”.
The added address is enclosed in brackets ([ ]), with the batch, file and page ad-
dresses added sequentially and separated by periods (.).Because batch, file and
pages addresses can each contain up to 9 digits, the added address consists of up
to 31 characters including the enclosing brackets and the separating periods.
(Input) (Add on result)
\A [123456.789012.345]
page batch file