Levana LV-TW500 - Manual (Page 13)

13
STEP 5 - PAIRING THE CAMERA AND USB RECEIVER
Setting up USB Receiver
Now that the proper software is installed on your computer, your computer will recognize the USB receiver as soon as it is
plugged into your computer.
To start viewing your camera footage through your computer
1. Make sure the camera is plugged in and turned on.
2. Make sure the USB receiver is plugged into a USB port on your computer.
3. Start the Secuexpress 2 watcher program on your computer.
Pairing the Receiver to Baby Camera:
Make sure both the camera and the receiver are fairly close to each other (in the same room). The camera should be
powered on.
1. With the USB receiver plugged in to the computer, press the camera selection button on the side to choose which camera
number you want to pair. The LED on top of the receiver will light up next to the camera number to be paired.
2. Press and hold the camera selection button on the side of the USB receiver down. The LED next to camera number that is
pairing will begin to flash for 5 seconds.
3. While the LED is flashing, hold down the night light button on the camera.
• You can also hold the pairing button on the receiver and the Night Light button down at the same time
4. Hold both buttons down for about 5 seconds.
5. When the lights on the camera flash three times the two units will be paired.
↑
↑
Note: The LV-TW500 USB receiver is set to automatically find the baby camera when it is plugged into a
computer. If the receiver does not automatically find the camera you have to pair the two devices.