Levana LV-TW500 - Manual (Page 8)

8
Setting up the Baby Camera:
Setting up your LV-TW500 baby camera is simple.
1. If you are plugging the camera in, choose the desired location you would like to place your baby
camera. Make sure it is within 6ft of a power source or an extension cable will be needed.
2. Place the baby camera into the magnetic base or camera mount and adjust the angle so that it is
looking towards the area you would like to monitor.
3. Plug adapter into a power source.
4. Plug the power adapter into the baby camera.
5. Slide the power switch to the ON position.
↑
STEP 1 - CAMERA SETUP
Plug Camera In
↑
Turn Switch On
Using the Night Light:
1. Press the button on the camera labeled “Light.” This activates the night lights on the camera.
The night light will remain on until the button is pressed again.
NOTE: We do not recommend using batteries with the night light. The battery life will
be less than 2.5 hours with the night light on.
Using Night Vision:
The camera has eight night vision LEDs so it can see in the dark. This night vision uses the power of
infrared light, which is 100% safe for babies. To turn on the infrared LEDs, you press the “Light” button
on the side of the camera, you will notice a faint red glow in the front of the camera; these are the
LEDs lit up.
Night Light