Longshine LCS-KL-2716M - Manual (Page 22)

21
Switch to left one channel
<Scroll Lock> →
→ → → <Scroll Lock> → → → → <Left Arrow>
Switch to right one channel
<Scroll Lock> →
→ → → <Scroll Lock> → → → → <Right Arrow>
<ALT> Channel Shift Function
1. Start <ALT> Channel shift Function
< ALT > channel shift function default was off. You can press Hot-Key
<Scroll Lock> twice, <ALT> and then press <Enter> to turn on or turn off
this function alternately.
2. Shift the channel by <ALT> key
Press left < ALT > or right < ALT > key twice, the PC channel will
automatically shift to left or right one channel (channel decrease / increase
to next) when < ALT > channel shift function is enabled.
Enable/Disable <ALT> channel shift function
<Scroll Lock> →
→ → → <Scroll Lock> → → → → < ALT > → → → → <Enter>
Switch to left one channel
<Left ALT> →
→ → → < Left ALT >
Switch to right one channel
<Right ALT> →
→ → → < Right ALT >
6.1.4 Channel Select - Cascade Chain Layer
You can select the active channel directly under cascade chain connection.
The following hot key sequence is used for quick channel selection.
Press <Scroll Lock> twice, <D>, the cascade channel number (1, 2, 3……16),
and Press <Enter>.
Channel select to first layer
< Scroll Lock > →
→ → → < Scroll Lock > → → → → <D> → → → → < CH-L1 > → → → → < Enter >
Channel select to second layer
< Scroll Lock > →
→ → → < Scroll Lock > → → → → <D> → → → → < CH- L1 >
→
→ → → <D> → → → → < CH-L2 > → → → → < Enter >