Muse Research Receptor manual v1.2 - Manual (Page 126)

10: Graphic UI - Loading Patches 126 Receptor Manual
The Load Panel contains the following elements:
•
List
This area displays either the Bank List or the Patch List, depending on which tab is depressed. For more
information, see “Bank and Patch Lists” on page 127.
• Prev/Next Patch Select buttons
These buttons duplicate the prev/next buttons found in Mix View (and elsewhere). Use these buttons to step
through patches one-at-a-time. As a shortcut, you can use your keyboard’s arrow keys. Click the DOWN
arrow to select the next patch. Click the UP arrow to select the previous patch. Click the LEFT or RIGHT
arrows to move between columns.
• Slot ID
The upper right corner shows you the name of the plugin and its Receptor slot.
If you’re selecting a patch for an INST or FX, the slot ID displays the Channel (CH x, where x = 1-16, B1,
B2, or M), followed by its location (SOURCE, FX A, FX B, FX C), followed by the name of the plugin
(VST or VSTi name).
If you’re selecting a SINGLE patch, the slot ID displays the word “SINGLE :” followed by the Channel
number (CH 1-16).
If you’re selecting a MULTI patch, the slot ID displays the word “MULTI”.
• Bank and Patch tabs
Use these tabs to switch the display to show either banks or patches. Basically, any time you want to load a
patch from a different bank, you would click the Bank tab, select the desired bank, then click the Patch tab
to see the list of patches contained in that bank. For more information about the Bank and Patch lists, see
“Bank and Patch Lists” on page 127.
• Close button
Click this button to close the Load Panel. Alternately, you could simply click outside the panel or type the
Enter key on your keyboard.
• Load Blank Patch button (Single and Multi patches only)
If you’re viewing the Load Panel for Single or Multi patches, you’ll see a button called “Load Blank Patch”
at the bottom of the Patch tab panel.
For a Multi patch, pressing this button loads a special patch that resets your Multi — uninstantiating every
plugin on every instrument channel and returning Receptor to its default configuration. This is the ideal
way to “wipe the slate clean” and start setting up an entirely new Multi patch from scratch.
Similarly, for a Single patch, pressing this button loads a special “blank” patch that resets your Single by
uninstantiating every plugin on that instrument channel and returning it to its default configuration.
Shortcut 1: You can load a blank Single or Multi patch without opening the Load Panel by control-clicking
the patch name in Mix view.
Shortcut 2: You can load a blank Multi patch using a front panel button shortcut -- simply press the front
panel’s SETUP button, then the METERS button, and Receptor will load a blank Multi patch.
• Info Area
This area displays the selected current bank’s name and MSB/LSB assignment.