Muse Research Receptor manual v1.2 - Manual (Page 130)

11: GUI - Saving and Managing Patches 130 Receptor Manual
Save/File Panel Architecture
Whenever you click the Save/File button within Receptor’s graphical user interface, you’ll be presented with a
standard Save/File panel for that patch type.
Bank & Patch Tabs Slot ID List
Save/File
options
Current Bank Info Close Button
--- Typical Save/File Panel ---
The Save/File Panel contains the following elements:
•
List
This area displays either the Bank List or the Patch List, depending on which tab is depressed. For more
information, see “Save/File Panel: Bank and Patch Lists” on page 131.
• Slot ID
The upper right corner shows you the name of the plugin and its Receptor slot.
If you’re saving a patch for an INST or FX, the slot ID displays the Channel (CH x, where x = 1-16, S1,
S2, or M), followed by its location (INST, FX A, FX B, FX C), followed by the name of the plugin (VST or
VSTi name).
If you’re saving a SINGLE patch, the slot ID displays the word “SINGLE:” followed by the Channel
number (CH 1-16).
If you’re saving a MULTI patch, the slot ID displays the word “MULTI”.
• Bank and Patch tabs
Use these tabs to switch the display to show either banks or patches. Basically, any time you want to save
a patch to a different bank, you would click the Bank tab, select the desired bank, then click the Patch tab
to see the list of patches contained in that bank and select which patch location to store the patch into. For
more information about the Bank and Patch lists, see “Save/File Panel: Bank and Patch Lists” on page 131.
• Save/File options
This area is where you perform the various Bank and Patch save and file management operations.
• Close button
Click this button to close the Save/File panel.